Garden Shed Installation Instructions

- Before you start erecting your garden shed, make sure the ground is flat and level.

1. Join walls together as shown in fig A. Use 4 screws in each corner.

2. Screw all four wall panels together making sure the shed is square diagonally and in the correct position. fig B.

3. Fit the ridge and ridgecap section to one of the roof panels. Screw through the under side ofthe ridge into the channel on the under side of the roof panel. (Make sure the weathered edge of the roof panel is fitted into the ridge section) fig C. 5 Screws.

4. Once the ridge is screwed to one of the roof panels, place the roof panel onto the shed walls. Make sure the centre ofthe ridge sits over the apex of the gable walls.

5. Screw the roof end flashing to the gable wall channel. 3 screws. fig D.

6. Place the second roof panel on the shed and slip it into the ridge section. Screw the end roof flashing to the gable wall channel.

7. From the inside of the shed screw the ridge to the roof panel. (Don’t pull down when screwing the roof panel)

8. On the outside of the shed, fold the ridgecap ends down and screw into place. Make sure walls are straight and screw roof panels to the top of the walls. fig D.

9. Make sure you anchor your shed down to the ground or floor. After shed is secured in place, fit pad bolt to the door ....